12 Volt
10 Amps Maximum Per Circuit
30 Amps Maximum Per Panel
5 Illuminating Switches
O.D.: 6-1/2" x 4-1/2"
- Connect the positive terminal of the battery (12V only) to the red
wire identified with a "+" tag.
- Connect the negative terminal of the battery (or ground) to the
black wire identified with a "-" tag.
- Connect the positive wire of each individual circuit to the #1 spade
on the corresponding rocker switch on the panel.
- Connect the remaining wire or negative wire of each circuit to the
common ground of the boat, if so equipped, or directly to the
negative terminal of the battery or the negative wire of the panel.
NOTE:Do not attach any additional wires to the remaining terminal
on the fuse holder.
- Your Sea-Dog Line switch panel is supplied with 6 fuses: (2) 3 amp,
(2) 5 amp, (1) 8 amp and (1) 10 amp. (WARNING: Do not use fuse
rated over 10 amps).
- To remove the fuse holder cap, see Fig. 2 below:
|
