- 12 Volt
- 10 Amps Maximum Per Circuit
- 37 Amps Maximum Per Panel
- 3 Illuminating Switches
- O.D.: 6-1/2" x 4-1/2"
- Connect the positive terminal of the battery (12V only) to the red wire identified
with "+" tag.
- Connect the negative terminal of the battery (or ground) to the black wire identified
with a "-" tag.
- Connect the positive wire of each individual circuit to the #2 spade on the corresponding
rocker switch on the panel.
- Connect the remaining wire or negative wire of each circuit to the common ground of the
boat, if so equipped, or directly to the negative terminal of the battery or the negative
wire of the panel.
- Connect terminal (1) of battery test switch (Fig. 1) to terminal (1) of battery selection
switch (Fig. 2). Connect terminal (3) of the battery test switch (Fig.1) to terminal (2)
of the battery selection switch (Fig. 2).
NOTE: Do not attach any additional wires to the remaining terminal on the fuse holder.
- Connect remaining terminal on horn button to positive terminal of horn.
- Your Sea-Dog Line switch panel is supplied with 3 fuses: (1) 3 amp, (1) 5 amp ,
and (1) 10 amp. The fuses should be used depending on each individual circuit load, with
maximum rating of 10 amps.
- To remove the fuse holder cap, see Fig. 3 below.
|
