Sea-Dog 6 Switch Vertical Panel
Model Number 424110-1 & 424116-1 
Installation Instructions  

12 Volt 
10 Amps Maximum Per Circuit 
37 Amps Maximum Per Panel 
6 Illuminating Switches 
O.D.: 6-1/2" x 4-1/2" 

1. Connect the positive terminal of the battery (12V only) to the red 
    wire identified with a "+" tag. 

2. Connect the negative terminal of the battery (or ground) to the 
    black wire identified with a "-" tag. 

3. Connect the positive wire of each individual circuit to the #2 spade 
    on the corresponding rocker switch on the panel. 

4. Connect the remaining wire or negative wire of each circuit to the 
    common ground of the boat, if so equipped, or directly to the 
    negative terminal of the battery or the negative wire of the panel.

    NOTE: Do not attach any additional wires to the remaining terminal 
    on the fuse holder. 

5. Your Sea-Dog Line switch panel is supplied with 6 fuses: (2) 3 amp, 
    (2) 5 amp, (1) 8 amp and (1) 10 amp. (WARNING: Do not use fuse 
    rated over 10 amps). 

6. To remove the fuse holder cap, see Fig. 2 below.

Insert a small screw driver in 
the slot. Push and turn 90 degrees
to left to open the cap.

Insert a small screw driver in 
the slot. Push and turn 90 degrees 
to right to close the cap.

Note:    The fuse holder needs a fuse in it to keep the cap from dropping off.