Sea-Dog 4 Switch Vertical Panel
Model Number 424010-1 & 424016-1 
Installation Instructions

12 VOLT 10 Amps Maximum Per Circuit 
37 Amps Maximum Per Panel 
4 Illuminating Switches 
O.D.: 4-7/8" x 4-1/2" 
Fire Resistant Injection Molded Nylon  

1. Connect the positive terminal of the battery (12V only) to the red wire identified 
    with a "+" tag. 

2. Connect the negative terminal of the battery (or ground) to the black wire 
    identified with a "-" tag 

3. Connect the positive wire of each individual circuit to the #2 spade on the 
    corresponding rocker switch on the panel. 

4. Connect the remaining wire or negative wire of each circuit to the common 
    ground of the boat, if so equipped, or directly to the negative terminal of the 
    battery or the negative wire of the panel. 

    NOTE: Do not attach any additional wires to the remaining terminal on the 
    fuse holder. 

5. Your Sea-Dog Line switch panel is supplied with 4 fuses - (2) 3 amp, (1) 5 amp, 
    and (1) 10 amp. (WARNING: Do not use fuse rated over 10 amps) 

6. To remove the fuse holder cap, see Fig. 2 below.
   

Insert a small screw driver in 
the slot. Push and turn 90 degrees
to left to open the cap.

Insert a small screw driver in 
the slot. Push and turn 90 degrees 
to right to close the cap.