12 VOLT
O.D.: 6-1/2" x 4-1/2"
3 ILLUMINATING SWITCHES
10 Amps PER CIGARETTE LIGHTER
10 Amps PER Circuit - 30 Amps PER Panel
- Connect the positive terminal of the battery (12V only) to the bar identified
with a "+" tag.
- Connect the negative terminal of the battery (or ground) to the bar identified
with a "-" tag.
- Connect the positive wire of each individual circuit to the #2 spade on the
corresponding rocker switch on the panel.
- Connect the remaining wire or negative wire of each circuit to the common
ground of the boat, if so equipped, or directly to the negative terminal of the
battery or the negative bar of the panel.
- Connect terminal (1) of battery test switch (Fig. 1) to terminal (1) of battery
selection switch (Fig. 2). Connect Terminal (3) of the battery test switch
(Fig. 1) to terminal (2) of the battery selection switch (Fig. 2).
NOTE: Do not attach any additional wires to the remaining terminal on the
fuse holder.
- Six fuses are supplied with your Sea-Dog panel: (2) 3A, (2) 5A, and
(2) 10A. Use the 10A fuse only for the black screw top fuse holder (B). The
remaining fuses should be used depending on each individual circuit load,
with maximum rating of 10 Amps.
- To remove the fuse holder cap, see Figure 3 below:
|
