- Connect the positive terminal of the battery (12V only) to the bar identified
with a "+" tag.
- Connect the negative terminal of the battery (or ground) to the bar identified
with a "-" tag.
- Connect the positive wire of each individual circuit to the #3 spade on the
corresponding rocker switch on the panel.
- Connect the remaining wire or negative wire of each circuit to the common
ground of the boat, if so equipped, or directly to the negative terminal of the
battery or the negative bar of the panel. NOTE: Do not attach any additional
wires to the remaining terminal on the fuse holder.
- Your Sea-Dog switch panel is supplied with 8 fuses - (2) 3A, (4) 5A and
(2) 10A. (WARNING: Do not use fuse rated over 10A).
- To remove the fuse holder cap, see figure 2 below:
|
