12 VOLT
10 Amps Maximum Per Circuit
30 Amps Maximum Per Panel
4 ILLUMINATING SWITCHES
O.D.: 4-7/8" x 4-1/2"

 1. Connect the positive terminal of the battery (12V only) to the bar identified 
     with a "+" tag. 

2. Connect the negative terminal of the battery (or ground) to the bar identified 
    with a "-" tag. 

3. Connect the positive wire of each individual circuit to the #2 spade on the 
    corresponding rocker switch on the panel. 

4. Connect the remaining wire or negative wire of each circuit to the common 
    ground of the boat, if so equipped, or directly to the negative terminal of the 
    battery or the negative bar of the panel. 

    NOTE: Do not attach any additional wires to the remaining terminalon the 
    fuse holder. 

5. Your Sea-Dog switch panel is supplied with 8 fuses: (2) 3A, (4) 5A and 
    (2) 10A. (WARNING: Do not use fuse rated over 10A). 

6. To remove the fuse holder cap, see fig. 2 below.